Pelco FMCI-PF1POE 10/100 Mbps Fiber Media Converter with PoE+ Output

Pelco FMCI-PF1POE 10/100 Mbps Fiber Media Converter with PoE+ Output

The Pelco FMCI-PF1POE is a miniature, single-channel 10/100 Mbps Ethernet fiber media converter that links IP cameras and network equipment over optical fiber. The RJ-45 port autonegotiates 10/100 Mbps and the optical port runs at 100 Mbps full duplex through a customer-installed FSFP small form-factor pluggable module, ordered separately, which sets the fiber type, connector and distance, such as the FSFP-EFSM2LC20. As IEEE 802.3at Power Sourcing Equipment it delivers up to 30 W at 48 VDC on the RJ-45 port to power the camera at the far end of the fiber, from a 48 VDC input. It is hardened for -40 to 75 C operation in traffic, transportation and campus installations.

Key Specifications

Full specifications are listed in the Detailed Specifications tab.

Installation

Insert the FSFP module into the optical port and connect the fiber, connect the camera or switch to the RJ-45 port, and apply power to the terminal block. Converters at each end of the link must use compatible FSFP modules and the same fiber type.

Compatible Products

• Pelco FSFP-EFSM2LC20 100 Mbps Single-Mode SFP, LC, 20 km

Use Pelco FSFP modules matched to the 100 Mbps optical rate; other Pelco FSFP fiber and connector options are available.

Related Products

• Pelco FMCI-PF1M Mini 10/100 Mbps Fiber Media Converter
• Pelco FMCI-PF2 Dual-Channel 10/100 Mbps Fiber Media Converter
• Pelco FMCI-PG1POE Gigabit Fiber Media Converter with PoE+ Output
• Pelco SURGEPR Lightning Surge Protector for Ethernet/PoE Lines

Explore More

• Shop Converters at Affinitech Store
• Browse all Network Camera Accessories at Affinitech Store
• See all Pelco products at Affinitech Store

Frequently Asked Questions About the Pelco FMCI-PF1POE

Does the FMCI-PF1POE include an SFP module?

No. It requires a Pelco FSFP module, ordered separately, which sets the fiber type, number of fibers, connector and distance. Pelco FSFP modules are required to qualify for the manufacturer warranty.

What data rates does it support?

The RJ-45 port autonegotiates 10/100 Mbps, full or half duplex. The optical port runs at 100 Mbps full duplex, so use a 100 Mbps Fast Ethernet FSFP module.

How far can it send data over fiber?

Distance depends on the FSFP module chosen, up to 120 km (74.5 mi) with a long-reach module.

Can it power a camera?

Yes. It is IEEE 802.3at Class 1-4 Power Sourcing Equipment and supplies up to 30 W at 48 VDC on its RJ-45 port. The unit itself needs a 48 VDC input; Pelco recommends the FEXTPS-48V external supply.

Is it rated for outdoor cabinets?

It operates from -40 to 75 C, 0 to 95 percent noncondensing humidity, and is designed to meet NEMA TS 1/TS 2 and Caltrans traffic signal equipment environmental standards.