Pelco PP351 Rooftop Parapet Mount for Small Pendant Domes, Gray

Pelco PP351 Rooftop Parapet Mount for Small Pendant Domes, Gray

The Pelco PP351 is a gray aluminum rooftop parapet mount that holds an outdoor pendant dome on 1.5-inch NPT pipe from a rooftop or other smooth horizontal surface. The arm swivels 360 degrees within available clearance for easy installation and service, indexing bolts lock it in position, and a removable end cap gives access to the wiring. It is rated for about 45 lb. Pelco lists the PP350/PP351 as recommended mounts for the light gray Spectra Pro IR P2230L-ESR.

Key Specifications

Full specifications are listed in the Detailed Specifications tab.

Installation

Attach the mounting base to the rooftop or horizontal surface with at least two 3/8-16 fasteners on each of its four sides (eight minimum, not supplied). Pull wiring up through the arm, thread on the dome, swing the arm into position and tighten the brake plate and indexing bolts. Seal around bolt holes where water could enter.

Compatible Cameras

• Spectra Pro IR P2230L-ESR 2MP 30x IR PTZ

Fits outdoor small-size pendant domes that use 1.5-inch NPT pipe.

Related Products

• Pelco PP451 Rooftop Parapet Mount, Gray
• Pelco PP350-AW Parapet Wall Mount, Light Gray
• Pelco IWM-SR Wall Mount, Light Gray

Explore More

• Shop Housings and Mounts at Affinitech Store
• Browse all Network Camera Accessories at Affinitech Store
• See all Pelco products at Affinitech Store

Frequently Asked Questions About the Pelco PP351

What does the Pelco PP351 mount to?

It mounts to a rooftop or other smooth horizontal surface.

Which cameras fit the PP351?

It is designed for outdoor small-size pendant domes that use 1.5-inch NPT pipe, such as Pelco Spectra and DF5 Series domes. Pelco recommends the PP351 for the Spectra Pro IR P2230L-ESR.

What is the load rating?

Approximately 45 lb (20.41 kg).

Is mounting hardware included?

No. Use 3/8-16 type fasteners suited to the surface, a minimum of eight, plus sealant around the bolt holes if needed.

Can I service the dome after installation?

Yes. The arm swivels within available clearance so the dome can be pulled back for maintenance, and the removable end cap provides access to the wiring.