Pelco PP350-AW Parapet Wall Mount for Small Pendant Domes, Light Gray

Pelco PP350-AW Parapet Wall Mount for Small Pendant Domes, Light Gray

The Pelco PP350-AW is a light gray aluminum parapet wall mount that holds an outdoor pendant dome on 1.5-inch NPT pipe from the inside or outside of a parapet wall. The arm swivels 360 degrees within available clearance for easy installation and service, indexing bolts lock it in position, and a removable end cap gives access to the wiring. It is rated for about 45 lb.

Key Specifications

Full specifications are listed in the Detailed Specifications tab.

Installation

Attach the mounting plate to the inside or outside of the parapet with at least three 3/8-16 fasteners per side (six minimum, not supplied), as close to the top as practical; mounting it 2 to 5 inches below the top lets the dome swing back over the parapet for service. Pull wiring up through the arm, thread on the dome, swing the arm into position and tighten the brake plate and indexing bolts. Seal around bolt holes where water could enter.

Compatible Cameras

• Pelco Spectra Series pendant domes
• Pelco DF5 Series pendant domes

Fits outdoor small-size pendant domes that use 1.5-inch NPT pipe.

Related Products

• Pelco PP350-SW Parapet Wall Mount, White
• Pelco PP351 Rooftop Parapet Mount, Gray
• Pelco PP450 Parapet Wall Mount, Gray
• Pelco IWM-SR Wall Mount, Light Gray

Explore More

• Shop Housings and Mounts at Affinitech Store
• Browse all Network Camera Accessories at Affinitech Store
• See all Pelco products at Affinitech Store

Frequently Asked Questions About the Pelco PP350-AW

What does the Pelco PP350-AW mount to?

It mounts to the inside or outside of a parapet or vertical wall.

Which cameras fit the PP350-AW?

It is designed for outdoor small-size pendant domes that use 1.5-inch NPT pipe, such as Pelco Spectra and DF5 Series domes.

What is the load rating?

Approximately 45 lb (20.41 kg).

Is mounting hardware included?

No. Use 3/8-16 type fasteners suited to the surface, a minimum of six, plus sealant around the bolt holes if needed.

Can I service the dome after installation?

Yes. The arm swivels within available clearance so the dome can be pulled back for maintenance, and the removable end cap provides access to the wiring.