Pelco FMCI-PG1M Mini Gigabit Fiber Media Converter, SFP Port

Pelco FMCI-PG1M Mini Gigabit Fiber Media Converter, SFP Port

The Pelco FMCI-PG1M is a miniature, single-channel Gigabit Ethernet fiber media converter that links IP cameras and network equipment over optical fiber. The RJ-45 port autonegotiates 10/100/1000 Mbps and the optical port runs at 1000 Mbps full duplex through a customer-installed FSFP small form-factor pluggable module, ordered separately, which sets the fiber type, connector and distance, such as the FSFP-EGSM2LC15. The compact housing wall mounts where space is limited and accepts 22 to 27 VAC or 8 to 24 VDC. It is hardened for -40 to 75 C operation in traffic, transportation and campus installations.

Key Specifications

Full specifications are listed in the Detailed Specifications tab.

Installation

Insert the FSFP module into the optical port and connect the fiber, connect the camera or switch to the RJ-45 port, and apply power to the terminal block. Converters at each end of the link must use compatible FSFP modules and the same fiber type.

Compatible Products

• Pelco FSFP-EGSM2LC15 Gigabit Single-Mode SFP, LC, 15 km

Use Pelco FSFP modules matched to the 1000 Mbps optical rate; other Pelco FSFP fiber and connector options are available.

Related Products

• Pelco FMCI-PG1 Gigabit Fiber Media Converter
• Pelco FMCI-PG1POE Gigabit Fiber Media Converter with PoE+ Output
• Pelco FMCI-PG2 Dual-Channel Gigabit Fiber Media Converter
• Pelco FMCI-PF1M Mini 10/100 Mbps Fiber Media Converter

Explore More

• Shop Converters at Affinitech Store
• Browse all Network Camera Accessories at Affinitech Store
• See all Pelco products at Affinitech Store

Frequently Asked Questions About the Pelco FMCI-PG1M

Does the FMCI-PG1M include an SFP module?

No. It requires a Pelco FSFP module, ordered separately, which sets the fiber type, number of fibers, connector and distance. Pelco FSFP modules are required to qualify for the manufacturer warranty.

What data rates does it support?

The RJ-45 port autonegotiates 10/100/1000 Mbps, full or half duplex. The optical port runs at 1000 Mbps full duplex, so use a Gigabit FSFP module.

How far can it send data over fiber?

Distance depends on the FSFP module chosen, up to 120 km (74.5 mi) with a long-reach module.

How is it powered?

It accepts 22 to 27 VAC or 8 to 24 VDC through a terminal block. Pelco recommends the FEXTPS external power supply, sold separately.

Can it be rack mounted?

No. The mini unit wall or surface mounts where space is limited.

Is it rated for outdoor cabinets?

It operates from -40 to 75 C, 0 to 95 percent noncondensing humidity, and is designed to meet NEMA TS 1/TS 2 and Caltrans traffic signal equipment environmental standards.